Author |
Message |
Al Broadbent
| Posted on Tuesday, April 20, 2004 - 10:27 pm: | |
Need intake and exhaust mainfold for Oliver 770 Gas (1963). Oliver Numbers: Intake 101339A, Exhaust 106213A. Intake more important. The intake pin alignment hole centerlines are 17" (most listed for 770 are 18"). The exhaust front to rear tube centerline distance is 24". Carb mount is 2-3/8". I've tried the White dealer network, Stiners and all local (MN and IA) sources I know. Would greatly appreciate any help or if someone has these laying on the bench? Thanks. My e-mail spam catcher will request a reply to assure you are a real person. I appologize for the inconvienence; however, I got tired of deleting 600 messages an hour. Thanks again. |
Wrenchbender
| Posted on Thursday, April 22, 2004 - 7:46 pm: | |
I have a used set. The intake has a couple cracks in the area bove the carb. I don't know if that will do you any good. I could possibly take a picture and e-mail to you. WB. |
Al Broadbent
| Posted on Saturday, April 24, 2004 - 11:50 pm: | |
Thanks. Found one last night that had been in shed for two years without engine being run. No cracks (almost all used ones have them). I've fixed a couple with nickel rod and brazed one; however, haven't had a whole lot of success repairing. Word is that a new supply of new ones (at high prices) will be available mid to late July. These are the actual 770 replacements, not the 8xx series that everyone seems to think will fit. Again, thanks a bunch for looking. I'll keep you in mind if I need another one.AB. |
|