    
David Scotton
Posted From: 70.152.133.186
| | Posted on Friday, March 30, 2007 - 8:32 am: | |
I did a z split on my 550 to remove and replace the clutch discs. Everything was going great until I got to actually removing the pto clutch assembly off the pto shaft. The set screw is directly below the locking pin housing on the floating plate. I can only see it from an angle and definitely can not get an allen wrench on it. The assembly turns as unit and there is very little clearance. How can I get the set screw out? Thanks David |
