| Author | Message | ||
     Chris Roberts |
I recently purchased an Oliver disk. I have not found the model number and I am not sure where it should be. It is an 8-9' wheeled disk. I believe I need some bearings where the axle goes through the hanger bracket.If anyone has any guesses as to the model of the disk or where exacltly the number would be, as well as where I can get parts I would appreciate the input. | ||
| Ian C. Campbell (Ianc) |
I'm only familiar with the 240 series and newer, but if the bearing is held between two stamped steel flanges and your gang bolt (the shaft that the discs and spools ride on) is 1 1/8' round I'm pretty sure the P/N is 237092B or 237092BS. I don't remember the "generic" number. Any AGCO dealer should have them on the shelf. |
